clayart at Yahoo! Groups
Ceramic Arts Discussion List |
| 1. Cracks after using porcelain |
| Hello everyone: Relative newcomer here, been potting for only a little over a month. I've read a lot about what causes cracks during drying and firing, but I |
| 2. posting to clayart again and again |
| you cannot post from yahoo, you cannot post from google, you cannot post from the acers website, you can post the same way we have posted for 12 years. |
| 3. clayart instructions for posting |
| ... from minnetonka: website http://www.visi.com/~melpots/ clayart site: http://www.visi.com/~melpots/clayart.html |
| 4. woodfire/woodturner |
| Why must I keep illustrating my ready-freddy mouth and Rush To Answer tendencies? Isn't telling all of you all over the world enough?? Anyway, I recognized |
| 5. Re: What is this material |
| Inaccurate posting of mine. Did a bit more looking and less remembering, so here is clarification. Trinity Ceramics sells Ranger Red Clay, but I'd swear that |
| 6. Re: Giant Goblets |
| Thanks all for the encouraging words. Normally I am in production mode..some basic pieces over and over again...it's the bread and butter (and a little |
| 7. Tool tip |
| I sent this idea to CM but I guess it didn't make the cut. I think it is awesome and use it all the time. I like small necks so I use the flosspick. It works |
| 8. CC B-mix rocks! |
| I just thought you might like an opinion on the cont. clays new b-mix. It is awesome. I was using cone 6 "super white" and this has the versitility of |
| 9. do not use website to post |
| i say again. send your message to: clayart@.... the website does not work. period. mel from minnetonka: website http://www.visi.com/~melpots/ |
| 10. Re: Have you seen this? |
| I realize what I am about to suggest sounds silly at first but if one can get a piece of clay near the center of a wheel, you can use a trimming tool to trim |
| Records 1 to 10 of 15 |
|